Cino HB2110 Manual do Utilizador descarregar pdf (Página 39)

Configure Your FuzzyScan

2-31

[Data Formatter]

Scan “Formatter Control” and set bar code symbology to “08”.

Scan 1st Insertion” and set the identified position to “06”, then

inserted characters to “09” (Hex Code of TAB), “53” (Hex Code

of S), “4E” (Hex Code of N).

Scan “2nd Insertion” and set the identified position to “12”, then

inserted character to “09”. In the final, you must scan “FIN”

(Finish) code to terminate this selection.

Scan “3rd Insertion” and set the identified position to “16”, then

inserted character to “09”. In the final, you must scan “FIN”

(Finish) code to terminate this selection.

[Data Replacer]

Scan “Replacer Control” and set bar code symbology to “08”.

Scan “1st Replacement” and set the identified position to “00”,

then replaced character to “41” (Hex Code of A).

[Data Organizer]

Scan “Organizer Control” and set bar code symbology to “08”.

Scan “1st Organization” and set the identified position to “16”,

then set the data transmission to “0” (forward).

Scan “2nd Organization” and set the identified position to “17”,

then set the data transmission to “1” (backward).

Scan “END” (Exit) to terminate the programming.

[Important Notice]

Please note that Condensed DataWizard will follow the preset

working flow as below:

Verifier  Formatter  Replacer  Organizer

So when you set the identified position in Data Organizer, you

must consider the inserted data which you already set via Data

Formatter.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 50 51

Sem comentários

Cino HB2110 Manual do Utilizador Página 39